Subject: Re: boss' computer
Name:
Bob Date: 11/26/2001 3:19:19 AM (GMT-7)
IP Address: 24.4.252.151 In Reply to: boss' computer posted by
joey Message:
Are you getting any fan movement when you hit the
the power switch ?
Try shorting the power on switch jumpers on MoBo.
Here is a way to turn the PS on if the MoBo is acting up & not turning on the PS, I do not have time to clean this up for you (going to work).
If you have an old AT P/S laying around you can use it straight forward.
If your P/S is an ATX type the green wire on the MoBo connector must be
connected to a black wire, the green wire is just grounded this way.
The black wire can be one on the MoBo connector (recommended)
or on a black wire on a 4 wire drive connector. Just cut the wires about
half way
between P/S & MoBo connector, stripe off about 1/2 inche of the wire
insulation
on the two wires leading from P/S & twist them together & wrap with wire
nuts or
& tape the connections when done.
To wire in the fan cut a drive connector's yellow & black wire, stripe
off about 1/2
inche of the wire insulation on the two wires leading from P/S & the
stripe fans red
& black wire also if needed. Now twist P/S black wire to fans black wire
& wrap
with wire nuts or & tape the connections when done. Now twist P/S yellow
wire to
fans red wire & wrap with wire nuts or & tape the connections when done.
Bob
|