|
Subject: Re: For all you AMD Fans
Name:
Bob
Date: 8/28/2001 2:46:12 PM (GMT-7)
IP Address: 24.4.252.151
In Reply to: For all you AMD Fans posted by
LED
Message:
The first piece of bull shit is the idea of cutting the bridges with a sharp knife. I did try
this method & it failed badly, I tried like 50 cuts on each of the 3 bridges I needed to cut to
make the change I needed, of course I needed to
pencil in some bridges too. Just look at the bridges with a large lighted magniflier & a brand new razor (xzato?) knife there is very little space. My high speed sears drill set does not have
a disk small enuf to cut something this small either. This could all be a bunch of bull.
Bob
|