win98se setup problem
Ups ] [ Post
Followup ] [ CPU-Central Message Board ] [ Home ]
Subject: win98se setup problem
Date: 7/19/2001 8:45:16 AM (GMT-7)
IP Address: 220.127.116.11
In Reply to: win98se setup problem posted by
Sorry about that first one!!
I try to install win98se (finnish) on my fathers computer (my old one)
After the first "counter" (where it counts to 100% you know) and says that the installation program is making the system ready for install etc. it says:
SUWIN caused a General Protection Fault in module 0367:0cca SUWIN will close
| Close |
After pressing "close" it closes the setup program and goes to DOS where it displays this:
Standard Mode: Bad Fault in MS-DOS Extender.
Fault:000D Stack Dump 0000 0000 0070
Raw Fault frame: EC=0000 IP=5ef7 CS=0367 FL=3087 SP=FF4E SS=02C7
Every time exatly same!
I have tried to install from the CD and tried to copy the CD to the HDD and install it from there but always the same error!
I have only the graphic card installed and I have tried with three different RAMs (they should work, they worked fine before).
I ran a surface check on the HDD but it didn't find aby errors.
Cel 466 (not clocked)
Asus v3800 tnt2 ultra.
memory 128MB (tried with more and less)
20GB HDD partioned C:~ 3.5GB D:8~GB E:~8.5GB (shouldn't be a problem?)
FollowUps | Post
Maximum of 100 messages displayed.
Post a Followup
Ups ] [ Post
Followup ] [ CPU-Central Message Board ]