|
Subject: Re: Overclocking a K6-2 500 to 550 ?
Name:
 ludicrous
Date: 3/4/2001 10:56:34 PM (GMT-7)
IP Address: 138.67.74.229
In Reply to: Re: Overclocking a K6-2 500 to 550 ? posted by
John Town
Message:
2.2v is default, default for the K6-2/550 is 2.3v but try clocking the freq FIRST then fool with voltage only if it won't boot or isn't stable.
You probably don't want to go over 2.4-2.5v at the most, assuming you have a decent cooling solution. You can take the voltage higher than that but I wouldn't reccommend it if you're new at this, or if you're dependent on this machine.
"VIA MVP3, VT82C598MVP" describes your chipset. "ATX" is the form factor (e.g. the size/layout, as opposed to AT, micro-ATX, flexATX, etc.) "WINBOND..." is probably the BIOS chip model number and has no direct relation to your board.
Basically, you need a manufacturer name and a board model number, e.g. "EPoX EP-MVP3G".
|